The Mississippi State University XV-11A Marvel was an experimental American STOL research aircraft of the 1960s. The MARVEL (Mississippi Aerophysics Research Vehicle with Extended Latitude) was a single-engined pushermonoplane fitted with a boundary layer control system. The first all-composite aircraft, it carried out its initial program of research on behalf of the US Army in the late 1960s, and was rebuilt in the 1980s as a proof-of-concept for a utility aircraft.
Development and design
The Department of Astrophysics and Aerospace Engineering at the Mississippi State University had been involved in a program of research into boundary layer control on behalf of the Office of Naval Research and the US Army since the early 1950s, carrying out trials on a modified Schweizer TG-3 glider, a Piper L-21 and a Cessna O-1.[1][2] Based on the results of these studies, the US Army awarded the Department a contract to develop a new STOL research aircraft the XV-11 MARVEL ("Mississippi Aerophysics Research Vehicle, Extended Latitude").[3]
The resultant design was a shoulder-winged monoplane powered by a single Allison T63turboprop engine driving a pusherducted propeller. The aircraft's structure was made completely of fiberglass, making the Marvel the first example of an all-composite aircraft.[4] The boundary layer control system used a blower driven by the engine to draw suction through more than one million tiny holes in the wings and fuselage, while instead of conventional flaps the Marvel used a form of wing warping to deflect the wing trailing edges to vary the wing's camber.[1] The aircraft's tail surfaces were attached to the duct around the propeller, extending behind the duct. The undercarriage, of the so-called "Pantobase" configuration, with tandem wheels fitted within two sprung wooden pontoons, was meant to allow operation from rough surfaces, or even from water.[3][5][6] It was constructed mainly of fiberglass, with steel used for reinforcement and as heat shields around the engine.[7]
Operational history
The XV-11 Marvel on display in August 2000
The aircraft's wing and ducted propeller were tested on a piston-engined test bed, the XAZ-1 Marvelette.[2][8] The full-sized Marvel was built by the Parsons Corporation based at Traverse City, Michigan,[1] making its first flight on December 1, 1965.[5] It successfully completed a 100-hour flying program for the US Army in 1969, where it demonstrated good STOL performance, taking off within 125 ft (38 m), and although the boundary layer control system was not as effective as hoped, it still provided a large amount of test data. Following the completion of the US Army testing in 1969, it was sent to storage awaiting further tests.[3][6][9]
The Marvel was brought out of storage as a proof-of-concept demonstrator of a STOL utility aircraft for Saudi Arabia. It was fitted with a more powerful (420 hp (313 kW)) engine and longer span (36 ft 10½ in (11.24 m) wings, first flying in this form as the Marvel II on August 17, 1982. After initial tests in the United States, the Marvel II was shipped to Ta’if, Saudi Arabia, carrying out a short test program which showed that its landing gear was unsuitable for operating from soft sand and it was still underpowered, after which it returned to Mississippi.[3][10]