Construction of the original 16.0-kilometre (9.9-mile) expressway from Jalan Istana to Serdang began in 1997, by Road Builder (M) Holdings Bhd (later acquired by IJM Corporation Berhad in 2007). The expressway used to be Selangor state road, B13, and the official name was Jalan Kuala Lumpur–Sungai Besi. During construction, the status of the road was changed to a tolled expressway and it was redesignated E9. The expressway commenced tolling operation on 15 May 1999.
The project to upgrade the Sungai Besi interchange from a half-diamond interchange to a non-stop interchange started in 2005 and completed in 2007.
The project to upgrade the Balakong interchange from a T-junction to a directional-T interchange started in 2004 and completed in 2006.
The Salak Jaya toll plaza was abolished on 24 February 2009.
Besraya Eastern Extension Expressway
Following the abolishment of toll collections at the Salak Jaya toll plaza on 25 February 2009, the then Works Minister, Mohd. Zin Mohamad announced the future expansion of the expressway, known as the Besraya Eastern Extension Expressway (BEE), whose concession would be awarded to Besraya. The expressway was completed on 2013 and was opened to traffic on 15 April 2014.
Motorcycles (Vehicles with two axles and two wheels)
Free
1
Private Cars (Vehicles with two axles and three or four wheels (excluding taxi and bus))
1.85
2
Vans and other small good vehicles (Vehicles with two axles and six wheels (excluding bus))
3.70
3
Large Trucks (Vehicles with three or more axles (excluding bus))
4
Taxis
1.85
5
Buses
1.30
1.85
List of interchanges
Main Link
This article contains a bulleted list or table of intersections which should be presented in a properly formatted junction table. Please consult this guideline for information on how to create one. Please improve this article if you can.(May 2022)
This section is missing kilometre posts for junctions. Please help by adding them.
This article contains a bulleted list or table of intersections which should be presented in a properly formatted junction table. Please consult this guideline for information on how to create one. Please improve this article if you can.(September 2022)